The board edges are raised and the centers sit lower
As our specialists document the loss, that is cupping, and it is the first stage of a wet wood floor.
Rooms and impacted areas
California
Our restoration specialists extract water from hardwood flooring and uses controlled drying to reduce cupping, warping, and moisture trapped below the boards.
Signs to look for
For the written restoration scope, if you notice any of these problems, call us before water has more time to spread into nearby materials.
As our specialists document the loss, that is cupping, and it is the first stage of a wet wood floor.
For the written restoration scope, that is crowning, and it in many cases means the floor was sanded flat while still wet or dried unevenly.
During our assessment, buckling means the floor has pushed up and separated from the deck, commonly several inches. From the first moisture reading, it happens when the boards swell so hard they overcome the fasteners.
During our assessment, peaking at the side joints means the planks have run out of room across the field.
As our specialists document the loss, a polyurethane finish traps water underneath and hazes as moisture pushes at it.
As our specialists document the loss, tannin and iron staining travels through the tongue and groove joints. From the first moisture reading, dark lines in many cases mean water has been sitting for more than a day.
What happens
Our restoration specialists adjust the work to the areas and materials involved, the measured reach of the water, and the materials that can be saved.
For the written restoration scope, standing water gets removed with hard surface extraction tools before anything else happens.
For the written restoration scope, we take wood moisture content readings across the impacted area and into dry boards for comparison.
During our assessment, solid hardwood, engineered hardwood, plank width, species and finish all change the plan.
For the written restoration scope, a hardwood drying mat seals to the surface and uses negative pressure to pull moisture up and out through the wood.
As our specialists document the loss, the deck under your boards is in many cases wetter than the boards themselves. As our specialists document the loss, we dry the subfloor and the wood together, from below where there is access.
For the written restoration scope, pulling a section of base shoe or lifting a threshold gives the floor room to move and gives air a path.
Talk with a restoration specialist
Describe the source, the impacted rooms, and when you first noticed the damage.
What to expect
Here is how we in many cases handle hardwood water removal near California.
During our assessment, say whether it is solid or engineered wood, how long it has been wet, and what leaked.
Your callFrom the first moisture reading, lift rugs, move furniture off the impacted area, and put foil or blocks under any metal feet you cannot move.
+5 minutesDuring our assessment, hard surface extraction pulls standing water while a technician maps wood moisture content across the room. During our assessment, you get the impacted area and a first read on the odds.
On arrivalDuring our assessment, we show you the readings, name the stage the floor is in, and price drying against replacement.
First hour on siteAs our specialists document the loss, the hardwood drying mat is laid over the mapped impacted area and sealed, then put under negative pressure.
Day 1From the first moisture reading, as sections reach target the panels shift to the boards that are still wet. From the first moisture reading, cupping in many cases starts easing between day three and day five.
Day 2 to 5As our specialists document the loss, we back the system off if the surface dries much faster than the wood beneath it.
Day 5 to 8Understanding the cost
We review with you the written restoration scope and price before you approve the job. These examples show what may change the estimate.
| Common situation | What the estimate may include | Typical range |
|---|---|---|
| Hardwood floor panel drying system with monitoring, per room | National estimate. Specialty panels and dehumidification in many cases run seven to fourteen days with daily readings. | $1,500 to $5,000 |
| Same day extraction and mat setup on one to two rooms | During our assessment, national estimate for the emergency response stage, covering surface extraction, metering and the first equipment set. | $500 to $1,500 |
| Open plan or multiple rooms of wood floor on a mat system | National estimate for the hardwood drying portion when the impacted area runs across several connected rooms. | $3,500 to $9,000 |
| Sand and refinish after the floor has equalized, per square foot | During our assessment, national estimate. | $3 to $8 |
| Remove and replace solid hardwood, per square foot | National estimate including tear out, disposal, new material and installation. Finishing is in many cases additional. | $8 to $20 |
| Engineered hardwood removal and disposal, per square foot | For the written restoration scope, national estimate for tear out and haul away only, where the wear layer has delaminated and drying is not an option. | $2 to $4 |
Square footage under mats or panels
We meter the floor and cover the impacted area, not the whole room. A leak that ran under one hallway is a fraction of an open floor plan.
Solid versus engineered construction
Solid hardwood dries and can be sanded more than once, so the save is commonly worth it. Engineered hardwood has a thin wear layer and moves toward replacement much faster.
Species, plank width and finish
For the written restoration scope, wide plank white oak holds more water per board than narrow strip maple.
Access below the floor
From the first moisture reading, a basement or crawl space lets us dry the subfloor from underneath at low cost.
Days on the system
As our specialists document the loss, air movers run roughly $25 to $40 per unit per day and Professional dehumidifiers roughly $70 to $110 per unit per day.
How long the floor sat wet
A floor reached the same day is in many cases a straight drying job. A floor found a week later commonly needs partial removal, which is a different work plan.
Why timing matters
Moisture can keep moving into nearby materials even when the surface looks dry.
During our assessment, boards that stay wet compress against each other at the edges and crush the wood fibers.
As our specialists document the loss, a floor that lifts off the deck has already broken its bond and its nails. For the written restoration scope, that is not a drying job, it is removal and replacement of the impacted area.
As our specialists document the loss, a polyurethane finish slows evaporation from the top, so water leaves through the seams and the underside.
During our assessment, engineered hardwood is a veneer glued to a core, and water breaks that glue.
Helpful service information
First identify the short explanation. Open a card if you want a little more detail.
As our specialists document the loss, as a board absorbs water it gets wider, and neighboring boards stop it from spreading.
During our assessment, wood moves across the grain, not along it, and that single fact explains everything a wet floor does.
For the written restoration scope, a polyurethane finish is close to a vapor retarder, so almost no moisture leaves through the surface.
From the first moisture reading, the finish on top is why hardwood needs specialty drying. For the written restoration scope, a polyurethane finish is close to a vapor retarder, so almost no moisture leaves through the surface.
During our assessment, pull moisture out of the surface much faster than the core releases it and the wood pays for it later.
During our assessment, drying wood fast is not the goal, drying it evenly is. During our assessment, pull moisture out of the surface much faster than the core releases it and the wood pays for it later.
Help near you
Identify your area below, or call (866) 318-2986 and describe how the loss began.
You may also need
Our restoration specialists remove surface water and dries moisture trapped beneath finished flooring to protect the subfloor and surrounding materials.
Get a Quote: (866) 318-2986Our restoration specialists use professional extraction equipment to remove water from flooring and building materials before detailed drying equipment is set.
Get a Quote: (866) 318-2986Our restoration specialists use air movement, dehumidification, and moisture monitoring to dry framing and building materials beyond the visible surface.
Get a Quote: (866) 318-2986Our restoration specialists dry walls, floors, framing, and other wet materials using balanced airflow, dehumidification, and repeat moisture readings.
Get a Quote: (866) 318-2986Our restoration specialists track moisture readings during drying and adjusts equipment when needed so wet materials continue moving toward a verified dry condition.
Get a Quote: (866) 318-2986Our restoration specialists extract water from carpet and padding, treats impacted areas, and determines whether the flooring can be safely restored.
Get a Quote: (866) 318-2986Our restoration specialists remove moisture from the air and wet materials, helping walls, flooring, and framing dry more evenly and completely.
Get a Quote: (866) 318-2986Our restoration specialists clean up water from sinks, dishwashers, refrigerators, and supply lines while drying cabinets, flooring, and adjoining rooms.
Get a Quote: (866) 318-2986Common questions
From the first moisture reading, often yes, especially solid hardwood reached in the first day or two. From the first moisture reading, mat and panel systems pull the water up through the boards.
For the written restoration scope, cupping is board edges rising higher than the centers, because wood swells across its width.
From the first moisture reading, crowning is the opposite shape, with the centers higher than the edges. During our assessment, it in many cases comes from sanding a floor flat while it was still cupped and wet.
During our assessment, buckling means the boards swelled so hard they lifted off the subfloor. During our assessment, the fasteners and the bond have already failed.
For the written restoration scope, a hardwood drying mat seals to the surface and is put under negative pressure.
From the first moisture reading, commonly seven to fourteen days on a mat system. As our specialists document the loss, wide plank floors and heavy finishes run longer.
For the written restoration scope, commonly 30 to 90 days after the equipment leaves, and sometimes a full heating season.
Talk with a restoration specialist
Describe the source, the impacted rooms, and when you first noticed the damage.
Areas we serve
Our restoration specialists assess homes, businesses, and managed properties throughout California and nearby communities.
View the area on Google Maps